Sofaware S-boxtm

Configuring Network Settings
56
Warning – If you change the S-box internal IP address, you may have to
manually change the network interface TCP/IP setting when using static
IP, or renew the DHCP lease when using Dynamic IP.
Otherwise, you may not have access to the SofaWare Safe@ Portal or to
the Internet.
To change IP addresses
1. In the Navigation Bar, click on Setup.
The Internet page appears.
2. In the Setup submenu, click on My Network.
The My Network page appears.
3. To change the S-box’s internal IP address, enter the new IP address in the
S-box LAN IP field.
4. To change the internal network range, enter new a new value in the LAN
Subnet Mask field.
Note – The internal network range is defined both by the S-box’s internal
IP address and by the subnet mask.
For example, if the S-box’s internal IP address is 192.168.100.7, and you
set the subnet mask to 255.255.255.0, the network’s IP address range
will be 192.168.100.1 – 192.168.100.254.
5. To reset the network to its default settings, click Default.
The internal network range is 192.168.10.*, and DHCP and NAT are
enabled.
6. Click Apply.
A warning message appears.
7. Click OK.
The S-box internal IP address and/or the internal network range are
changed.
8. Do one of the following:
� If your computer is configured to obtain its IP address automatically
(using DHCP), and the S-box DHCP server is enabled, restart your
computer.
Your computer obtains an IP address in the new range.
� Otherwise, manually reconfigure your computer to use the new
address range using the TCP/IP settings. For instructions, see “TCP/IP
Settings,” page 18.
SofaWare S-box Getting Started Guide