XTreme EMS Manual - MGL Avionics

More documents

Recommendations

Info

XTreme-EMS Operating Manual Page 52 6 Loading factory default settings Press and hold the left and right most soft keys simultaneously on power up to load default factory settings. The following message will be displayed: 7 Alarm condition If an alarm condition occurs the following will happen: • The item causing the alarm condition will flash on the screen • An alarm warning message will be displayed on the screen • An external alarm switch will close The alarm warning message and switch closure will remain until any button is pressed or until the condition(s) that activated the alarm no longer exist. The alarm output can be used to switch an external alarm indicator. The external alarm switch is an open collector transistor switch to ground with a maximum rating of 0.5A DC. It is possible to wire the alarm contacts of several Stratomaster instruments in parallel should this be desired. To avoid false activation of the alarms, the alarm function is only active 10 seconds after the instrument has powered up. 8 Cleaning The unit should not be cleaned with any abrasive substances. The screen is very sensitive to certain cleaning materials and should only be cleaned using a clean, damp cloth. Warning: The XTreme-EMS is not waterproof. Serious damage could occur if the unit is exposed to water and/or spray jets.
XTreme-EMS Operating Manual Page 53 9 XTreme-EMS Specifications Operating Temperature Range -10ºC to 50ºC (14ºF to 122ºF) Storage Temperature Range -20ºC to 80ºC (-4ºF to 176ºF) Humidity
Page 1 and 2: XTreme - EMS Universal Engine Monit
Page 3 and 4: XTreme-EMS Operating Manual Page 3
Page 51: XTreme-EMS Operating Manual Page 51
Page 59: XTreme-EMS Operating Manual Page 59

XTreme EMS Manual - MGL Avionics

Create successful ePaper yourself

Delete template?

Save as template?