C - Peterbilt Motors Company
C - Peterbilt Motors Company
C - Peterbilt Motors Company
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
injury, avoid unnecessary<br />
contact with the lubricating<br />
oil. Wear protective clothing,<br />
eye wear and gloves when<br />
handling lubricating oil.<br />
Failure to comply may result<br />
in personal injury.<br />
Full-flow Oil Filter Installation<br />
1. Lightly oil the new O-ring.<br />
2. Install a new O-ring onto the screw<br />
cap.<br />
3. Install the screw cap, with the<br />
oil filter cartridge, onto the filter<br />
housing. Tighten the screw<br />
cap to 354 lb-in (40 Nm). Use<br />
a hexagonal socket to avoid<br />
damaging the oil filter cap.<br />
Maintenance Procedures<br />
After Replacing Oil Filter(s)<br />
1. Reconnect the chassis battery<br />
cable at the negative battery<br />
terminal. See Warnings at<br />
Centrifugal oil filter removal<br />
preparation.<br />
2. Add approved engine oil SAE<br />
15W40 (API CJ-4) to the maximum<br />
level marked on the dipstick.<br />
3. Start and run the engine for five<br />
to ten minutes and check for any<br />
oil leaks.<br />
4. Remove oil collection pan and<br />
dispose of any spillage properly.<br />
5. Check engine oil level and top up<br />
as necessary.<br />
° chassis must be on level<br />
surface<br />
° wait at least five minutes if the<br />
engine has been hot<br />
° pull the dipstick and wipe with<br />
a clean, lint free cloth<br />
5-25<br />
5
Change language