Untitled

More documents

Recommendations

Info

Instructions on how to use the memory card ● Be sure to format the memory card (see p.48) if you are using a newly purchased memory for the first time, if it contains data that the camera cannot recognise, or if it contains images captured with a different camera. ● Turn off the camera power whenever the memory card is being inserted or removed. ● Repeated use of the memory card will eventually reduce the memory card’s performance. Should this be the case, you will need to purchase a new memory card. Wear and tear on the memory card is not covered by the Samsung warranty. ● The memory card is an electronic precision device. Do not bend, drop or subject the memory card to any heavy impact. ● Do not store the memory card in an environment with strong electronic or magnetic fields, e.g. near loud speakers or TV receivers. ● Please do not use or store in an environment where there are extremes in temperature. ● Do not allow the memory card to become dirty or to come into contact with any liquid. Should this happen, clean the memory card with a soft cloth. ● Please keep the memory card in its case when not in use. ● During and after periods of extended use, you may notice that the memory card is warm. This is perfectly normal. ● Do not use a memory card that is used in another digital camera. To use the memory card in this camera, format the memory card using this camera. ● Do not use a memory card formatted by another digital camera or memory card reader. ● If the memory card is subjected to any of the following, the recorded data may become corrupted : - When the memory card is used incorrectly. - If the power is switched off or the memory card is removed while recording, deleting (formatting) or reading. ● Samsung cannot be held responsible for lost data. ● It is advisable to copy important data onto other media as back-up e.g. floppy disks, hard disks, CD etc. ● If there is insufficient memory available : A [Memory Full!] message will appear and the camera will not operate. To optimise the amount of memory in the camera, replace the memory card or delete unnecessary images stored on the memory card. INFORMATION ● Don't remove the memory card when the camera status lamp is blinking as this may cause damage to data in the memory card. 《13》
Instructions on how to use the memory card ■ The camera can use SD/ SDHC Memory Cards and MMC (Multi Media Cards). Card pins Write protect switch Label [SD (Secure Digital) memory card] The SD/ SDHC memory card has a write protect switch that prevents image files from being deleted or formatted. By sliding the switch to the bottom of the SD memory card, the data will be protected. By sliding the switch to the top of the SD memory card, the data protection will be cancelled. Slide the switch to the top of the SD memory card before taking a picture. ■ When using a 256MB MMC memory, the specified shooting capacity will be as follows. These figures are approximate as image capacities can be affected by variables such as subject matter and memory card type. Recorded image size Super Fine Fine Normal 30FPS 15FPS Still image Movie * clip 71 139 206 - - 79 156 230 - - 94 184 270 - - 99 193 284 - - 156 301 435 - - 435 681 979 - - - - - About 10' About 16' - - - About 34' About 39' ※ The recording times can be changed by the zoom operation. The zoom button doesn’t use during the movie recording. 《14》
Page 2 and 3: Instructions ■ Use this camera in
Page 4 and 5: Caution CAUTION indicates a potenti
Page 6 and 7: System chart Please check that you
Page 8 and 9: Identification of features Back Cam
Page 10 and 11: Identification of features ■ Self
Page 12 and 13: Connecting to a Power Source ■ Yo
Page 16 and 17: LCD monitor indicator ■ The LCD m
Page 18 and 19: Starting the recording mode ■ How
Page 20 and 21: Starting the recording mode ■ How
Page 22 and 23: ZOOM W / T button ● WIDE Zoom Opt
Page 24 and 25: Macro ( ) / Down button ■ Availab
Page 26 and 27: Flash ( ) / Left button ● Availab
Page 28 and 29: E (Effect) button ■ It is possibl
Page 30 and 31: Special Effect (E button) : FUN Pre
Page 32 and 33: Special Effect (E button) : FUN ●
Page 34 and 35: Fn button ■ You can use the Fn bu
Page 36 and 37: Metering ■ If you cannot obtain s
Page 38 and 39: White balance ● Using the Custom
Page 40 and 41: Using the LCD monitor to adjust the
Page 42 and 43: Voice Recording Recording the movie
Page 44 and 45: [ Beep Sound ] Sound ( ) ■ If you
Page 46 and 47: [ Language ] Setup 1 ( ) ■ There
Page 48 and 49: Setup 2 ( ) [ LCD save ] ■ If you
Page 50 and 51: Starting play mode ■ If the memor
Page 52 and 53: Starting play mode ● Playing back
Page 54 and 55: Thumbnail ( ) / Enlargement ( ) but
Page 56 and 57: Delete ( ) button ■ This deletes
Page 58 and 59: Special Effect (E button) : Rotatin
Page 60 and 61: Special Effect (E button) : Image e
Page 62 and 63: Special Effect (E button) : FUN ※
Page 64 and 65:
Setting up the play back function u
Page 66 and 67:
Starting the slide show ( ) ● Set
Page 68 and 69:
Playback ( ) INFORMATION ● Of all
Page 70 and 71:
Playback ( ) ■ Index : Images (ex
Page 72 and 73:
PictBridge ■ You can use the USB
Page 74 and 75:
PictBridge : Reset Important notes
Page 76 and 77:
Warning indicator ■ There are sev
Page 78 and 79:
Before contacting a service centre
Page 80 and 81:
Specifications Storage 3072X 2304 -
Page 82 and 83:
About the software After inserting
Page 84 and 85:
Setting up the application software
Page 86 and 87:
Starting PC mode ■ Connecting the
Page 88 and 89:
Removing the removable disk ■ Win
Page 90 and 91:
Digimax Master ■ You can download
Page 92 and 93:
FAQ Digimax Master ● Movie edit :
Page 94 and 95:
Correct Disposal of This Product Co
Page 96 and 97:
MEMO MEMO 《95》
show all

Untitled

Create successful ePaper yourself

Delete template?

Save as template?