Industrial seal self study guide - SKF.com
Industrial seal self study guide - SKF.com
Industrial seal self study guide - SKF.com
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Chapter 8 Review<br />
To take this test, simply place a card or sheet of paper under the first question. After<br />
you’ve read it (and answered it to your<strong>self</strong>), slide the paper down below the next question.<br />
The correct answer to the first problem will appear directly to the right of the new question.<br />
Be sure not to skip any questions.<br />
76<br />
1 . The <strong>seal</strong> is ready to be installed in the bore when _________________ .<br />
❑ a. the shaft and bore have been checked and cleaned<br />
❑ b. the <strong>seal</strong> has been pre-lubricated<br />
❑ c. both of the above<br />
❑ d. none of the above<br />
2. For best <strong>seal</strong> performance, use a(n) _________________ or soft-face hammer<br />
for <strong>seal</strong> installation.<br />
❑ a. screwdriver<br />
❑ b. arbor press<br />
❑ c. chisel<br />
❑ d. steel hammer<br />
3. Press-fitting tools should have an outside diameter approximately _________________<br />
the bore size.<br />
❑ a. .010” (.254mm) smaller than<br />
❑ b. .010” (.254mm) larger than<br />
❑ c. equal to<br />
❑ d. none of the above<br />
3. A<br />
4. Seals which are to be flush with the outside of the housing can be pressed<br />
in with a _________________ .<br />
❑ a. drift<br />
❑ b. punch<br />
❑ c. block of wood<br />
❑ d. chisel<br />
5. The wrong installation tool can _________________ .<br />
❑ a. cut the <strong>seal</strong> lip<br />
❑ b. damage the <strong>seal</strong> case<br />
❑ c. distort the <strong>seal</strong><br />
❑ d. all of the above<br />
6. A <strong>seal</strong>ing lip that is cut, turned back or damaged should be _________________ .<br />
❑ a. repaired<br />
❑ b. replaced<br />
❑ c. cleaned<br />
❑ d. chamfered<br />
1. C<br />
2. B<br />
4. C<br />
5. D<br />
6. B