Industrial seal self study guide - SKF.com
Industrial seal self study guide - SKF.com
Industrial seal self study guide - SKF.com
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
7. Careless installation is a <strong>com</strong>mon reason for <strong>seal</strong> problems.<br />
❑ True ❑ False<br />
8. In wooden block installation, the <strong>seal</strong>ing force of the installation tool should be applied<br />
uniformly across the <strong>seal</strong> case, not concentrated in the center.<br />
❑ True ❑ False<br />
8. T<br />
9. A cocked <strong>seal</strong> is perpendicular to the shaft and bore.<br />
❑ True ❑ False<br />
10. Shaft and bore diameters should match those specified for the <strong>seal</strong> selected.<br />
❑ True ❑ False 10. T<br />
7. T<br />
9. F<br />
11. An arbor press does not apply uniform pressure against a <strong>seal</strong>.<br />
❑ True ❑ False<br />
11. F<br />
12. A direct blow on one side of the <strong>seal</strong> distorts the shell and can cause the lip to be<br />
pressed against the shaft.<br />
❑ True ❑ False<br />
12. T<br />
13. The new <strong>seal</strong> should face the opposite direction of the original one.<br />
❑ True ❑ False<br />
13. F<br />
14. Using the arbor press method to set the <strong>seal</strong> perpendicular to the shaft when<br />
installing a “through” bore, apply pressure through a steel plate or plug larger than<br />
bore diameter.<br />
❑ True ❑ False<br />
14. T<br />
15. The best pre-lube to use is the lubricant being retained by the <strong>seal</strong>.<br />
❑ True ❑ False<br />
16. V-rings can not be stretched when installing them on shafts.<br />
❑ True ❑ False<br />
15. T<br />
16. F<br />
17. Control wire connections on HS7 split <strong>seal</strong>s can be used for oil <strong>seal</strong>ing applications<br />
❑ True ❑ False<br />
17. F<br />
18. With V-rings, it doesn’t matter where they are positioned on the shaft so long as the<br />
shaft diameter is correct.<br />
❑ True ❑ False<br />
18. F<br />
8<br />
77