Industrial seal self study guide - SKF.com
Industrial seal self study guide - SKF.com
Industrial seal self study guide - SKF.com
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Chapter 9 Review (cont...)<br />
8. Garter spring damage requires careful inspection, often necessitating<br />
calling in an “expert.”<br />
❑ True ❑ False<br />
9. For out-of-round shaft repairs, a Speedi-Sleeve or <strong>SKF</strong> Large Diameter Wear<br />
Sleeve is often a better solution than shaft removal and reshaping.<br />
❑ True ❑ False<br />
10. When examining for STBM, the lip area with the least wear indicates<br />
the direction of shaft misalignment.<br />
❑ True ❑ False<br />
11. When using a wooden workpiece for flush installation of a <strong>seal</strong>, it is acceptable<br />
to use a steel hammer.<br />
❑ True ❑ False<br />
12. Because <strong>seal</strong> I.D. is easy to measure, only three measurements need<br />
to be taken and averaged.<br />
❑ True ❑ False<br />
8. F<br />
9. F<br />
10. F<br />
11. T<br />
12. F<br />
13. When determining the cause of a leak, remove the <strong>seal</strong> immediately and inspect it.<br />
❑ True ❑ False<br />
13. F<br />
14. If there is a history of <strong>seal</strong> failures for a particular installation, the problem<br />
may not be the <strong>seal</strong>’s fault.<br />
❑ True ❑ False<br />
15. A hammer blow without any material to absorb the shock wave can<br />
dislodge the garter spring from its proper operating position.<br />
❑ True ❑ False<br />
14. T<br />
15. T<br />
16. A swollen appearance and soft feel to a <strong>seal</strong>’s rubber element probably indicates<br />
chemical in<strong>com</strong>patibility with the system media.<br />
❑ True ❑ False<br />
16. T<br />
17. There is no problem installing a <strong>seal</strong> into a bore without a lead-in chamfer.<br />
❑ True ❑ False<br />
17. F<br />
86