RF-TIMBER Pro - Dlubal Software

2 Input Data
Service Class SECL
The classification into service classes makes it possible to assign strength parameters and to
calculate deformations by taking into account environmental conditions. The service classes
are specified for example in [4] section 2.3.1.3.
By default the program assigns a standard service class to the entire structure. If you want
to classify members or sets of members into different service classes, activate the selection
field Different. To open the following dialog box, use the [Assign] button displayed to the
right.
Figure 2.14: Dialog box Assign Members/Sets of Members to Corresponding Service Classes
The dialog box allows you to assign members and sets of members individually to service
classes. The buttons are reserved for the following functions:
Button
Function
Select members/sets of members graphically for service class
Assign all members/sets of members to respective service class
Assign all members/sets of members not yet assigned to respective service
class
Table 2.2: Buttons in the dialog box Assign Members/Sets of Members to Corresponding Service Classes
Program RF-TIMBER Pro © 2011 Ing. Software Dlubal
21