You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
3 Calculation<br />
3.1.5 Other<br />
Figure 3.5: Dialog box Details, tab Other<br />
Cross-section Optimization<br />
In case the optimization is not targeted on the maximum design ratio of 100 %, you can<br />
specify another limit value in this input field.<br />
Check of Member Slendernesses<br />
The two fields allow for the input of limit values λ limit in order to define member slendernesses.<br />
It is possible to enter specifications separately for members with pure tension forces<br />
and members with bending and compression.<br />
In the results table 3.3, the limit values are compared to the real member slendernesses.<br />
This table is available only after the calculation (see chapter 4.8, page 42) when the corresponding<br />
check mark has been set in the dialog section Display Result Tables to the right.<br />
Display Result Tables<br />
In this dialog section, you can select the results tables including parts lists that you want to<br />
display in the output. The individual results tables are described in chapter 4.<br />
Results table 3.3 Member Slendernesses is set inactive by default but can be activated for a<br />
specified evaluation by ticking the check box.<br />
<strong>Pro</strong>gram <strong>RF</strong>-<strong>TIMBER</strong> <strong>Pro</strong> © 2011 Ing. <strong>Software</strong> <strong>Dlubal</strong><br />
33
Change language