Micron

More documents

Recommendations

Info

V E C T O R O W N E R ’ S M A N U A L INSTALLING A RESERVE LANYARD (RESERVE STATIC LINE OR RSL) 1. Inspect the RSL: Check the stainless steel snap shackle is operating smoothly and that the spring will retain the locking pin. Check that the hook and loop fastener is clean and sufficiently tacky to hold the reserve lanyard in place. The pin should be curved from the eye to half way down its length. The rest of the pin should be straight. 2. Start by routing the RSL along its hook and loop fastener path along side the right-hand riser. Insert the pin-end of the RSL through the guide ring on the #6 top reserve flap. Mate the patch of yellow pile hook and loop fastener on the top reserve flap. note RSLs should only be installed by a qualified rigger. 3. After threading the reserve ripcord through the housing and placing the ripcord handle into its pocket, insert the RSL pin through the loop at the end of the reserve ripcord cable. 4. Place the rig on a clean surface facing up and walk on it with stocking feet or clean shoes to help expel air from the container and to make it flatter. Page • 36:88 section 3 : installing a reserve static line 09354 - 11/26/2003 Rev 0
V E C T O R O W N E R ’ S M A N U A L 5. Replace the temporary pin with the reserve pin. 6. Insert the stiffened part of the RSL (located close to the snap shackle) into the holding pocket located under the reserve risers. 7. Attach the main parachute risers to the harness. 8. Hook the reserve lanyard shackle to the ring on the right-hand riser. 9. Dress the container, seal, sign and log the reserve. 10. Count your tools. 09354 - 11/26/2003 section 3 : installing a reserve static line Page • 37:88 Rev 0
Page 1 and 2: Rev 0
Page 3 and 4: ○ ○ ○ ○ ○ ○ ○ ○ ○
Page 5 and 6: V E C T O R O W N E R ’ S M A N U
Page 23 and 24: COMMONLY USED TOOLS V E C T O R O W
Page 35: V E C T O R O W N E R ’ S M A N U
Page 87 and 88:
V E C T O R O W N E R ’ S M A N U
Page 89:
Rev 0
show all

Micron

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?