24.04.2015 Views

Micron

Micron

Micron

SHOW MORE
SHOW LESS

Create successful ePaper yourself

Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.

V E C T O R O W N E R ’ S M A N U A L<br />

9. Check the canopy with the deployment brakes set and with the brakes not set to be sure that it is correctly configured.<br />

The main canopy owner’s manual contains the correct brake settings and steering line lengths. Keep in mind that there<br />

are NO standardized dimensions. Therefore, unless the lines are the correct length, the canopy may not open or fly<br />

correctly.<br />

10. Once the measurements have been verified, tighten the overhand knot at the toggle. Daisy chain, finger trap or<br />

tack the excess end of the steering line to the toggle. Don’t cut the extra line off; you may wish to adjust the toggle<br />

position later.<br />

11. Repeat procedure for the other toggle.<br />

12. Inspect the installation. Ensure proper routing of the steering lines.<br />

METHOD B—SPECTRA (MICROLINES) LINES<br />

After the main canopy has been properly attached to the risers and while it is still lying on its side, attach the toggles to<br />

it by following these steps:<br />

1. Starting at the tail of the canopy, trace the upper steering lines down to the lower steering line. The idea is to be sure<br />

the steering lines are routed correctly; they should not wrap around any suspension lines. The right-hand steering line<br />

must pass through the right-hand rear slider grommet, and the left-hand line must pass through the left-hand rear<br />

slider grommet.<br />

2. Locate the mark on the steering line that indicates the correct toggle location. Verify that this mark is in the correct<br />

location by referring to the main canopy owner’s manual.<br />

3. Thread the end of the steering line through the guide ring located on the riser.<br />

4. Thread the end of the steering line through<br />

the Vector 3 steering toggle grommet. Wrap the<br />

steering line around the outside of the toggle<br />

and then over the grommet. The mark on the<br />

steering line that indicates correct toggle<br />

position should be 1 ¼ inches (3cm) from the<br />

side of the toggle.<br />

5. Slide the line off the looped end of the toggle<br />

and tie a loose overhand knot in the folded line.<br />

Page • 44:88 section 4 : attaching main steering toggles, spectra lines<br />

09354 - 11/26/2003<br />

Rev 0

Hooray! Your file is uploaded and ready to be published.

Saved successfully!

Ooh no, something went wrong!