Micron

More documents

Recommendations

Info

V E C T O R O W N E R ’ S M A N U A L 4. Fold the bight of line between the toggle and loop with 3 inches (7cm) folds and stow it in the hook and loop fastener tab next to the toggle. Repeat the procedure for the left-hand toggle. STOWAGE OF EXCESS STEERING LINES ON TRULOK TOGGLED RISERS Warning: Always stow excess steering line. Failure to do so may result in a knotted steering system and uncontrollable canopy. The TruLok toggle system allows the most secure steering line stowage available. Nevertheless, always look at your toggles before releasing, to make sure a clean release is possible. 1. Place the toggle tip through the cat eye on the steering line in the normal fashion. 2. Insert the tip of the toggle into the keeper located above the riser ring. Page • 52:88 section 4 : packing the main container 09354 - 11/26/2003 Rev 0
V E C T O R O W N E R ’ S M A N U A L 3. Pass the excess steering line through the two small loops of material located on the reverse side of the riser with the toggle assembly. 4. Take the loop that has been created by slipping the excess steering line and bring it around the riser so that you can place it over the straight pin of the trulok. 5. Insert the straight pin into the channel that has been created in the material holding the ring to the riser. note For those canopies with longer excess steering lines you can position the excess so that there is an even amount on both the top and bottom loops. 09354 - 11/26/2003 section 4 : packing the main container Page • 53:88 Rev 0
Page 1 and 2: Rev 0
Page 3 and 4: ○ ○ ○ ○ ○ ○ ○ ○ ○
Page 5 and 6: V E C T O R O W N E R ’ S M A N U
Page 23 and 24: COMMONLY USED TOOLS V E C T O R O W
Page 51: V E C T O R O W N E R ’ S M A N U
Page 89: Rev 0

Micron

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?