You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
V E C T O R O W N E R ’ S M A N U A L<br />
3. Use your knees or feet to “walk” on the bag,<br />
squeezing air out and distributing the bulk<br />
until the packed canopy is uniformly<br />
distributed within the bag.<br />
8. Kneel on the center of the bag and pull<br />
up the main container side flaps until the<br />
bag fills the container and is flush with the<br />
container.<br />
CLOSING THE MAIN CONTAINER<br />
1. Insert a pull-up cord through the<br />
closing loop located on the bottom flap of<br />
the main container (Hint: this is a good time<br />
to check the condition of the closing loop<br />
to ensure no fraying and to ensure your pilot<br />
chute is cocked, if applicable).<br />
2. Route the bridle to the right of the<br />
container. Correct bridle routing is CRITICAL<br />
if the Vector 3 is to function properly. The<br />
position of the pin (whether it is from right to<br />
left or vice versa) is much less critical, as it will<br />
release from all possible angles.<br />
3. Thread the pull-up cord through the<br />
grommet of the top container flap (flap #1).<br />
Pull the pull-up cord towards the bottom of<br />
the container (avoid overstressing the<br />
grommet). Placing your knee on the closing<br />
loop will help hold it in place.<br />
Page • 56:88 section 4 : closing the main container<br />
09354 - 11/26/2003<br />
Rev 0