Micron

More documents

Recommendations

Info

V E C T O R O W N E R ’ S M A N U A L PACKING THE PULL OUT DEPLOYMENT SYSTEM 1. When closing the main, place the bag in the pack tray as usual, with the lines at the bottom of the container. S-fold the bridle over the bag as shown. 2. At the bottom right outside corner of the container is a flap. Secure the soft deployment handle to the hook and loop fastener under this flap, and the hook and loop fastener tab opposite the pin just above it. 3. S-fold the stretched-out pilot chute on top of the bag so that it fits over the main bag, and is centered as shown at right. Page • 62:88 section 4 : packing pull out deployment system 09354 - 11/26/2003 Rev 0
V E C T O R O W N E R ’ S M A N U A L 5. Close the top flap #1, again keeping the pin to the right and outside the flaps to the bottom, as shown. 6. Close side flaps #2 and #3 and secure with the main closing pin. note Make sure there are no twists in the bridle and make sure the bridle is not looped around the tab that has the grommet set in it 7. Slowly remove the pull-up cord under the closing pin while extracting it. Doing so will reduce the wear and tear on the loop. Close the main pin cover flap and make sure it completely covers the pin and bridle cord. Tuck any excess bridle under the right side flap. 09354 - 11/26/2003 section 4 : packing pull out deployment system Page • 63:88 Rev 0
Page 1 and 2:
Rev 0
Page 3 and 4:
○ ○ ○ ○ ○ ○ ○ ○ ○
Page 5 and 6:
V E C T O R O W N E R ’ S M A N U
Page 7 and 8:
Page 9 and 10:
Page 11 and 12: V E C T O R O W N E R ’ S M A N U
Page 23 and 24: COMMONLY USED TOOLS V E C T O R O W
Page 61: V E C T O R O W N E R ’ S M A N U
Page 89: Rev 0
show all

Micron

Create successful ePaper yourself

Delete template?

Save as template?