Micron

More documents

Recommendations

Info

V E C T O R O W N E R ’ S M A N U A L 4. Fold the pilot chute in half so that the handle is even with the skirt. 5. Before inserting the pilot chute into the pouch, pat the bottom of the rig to flatten out the pouch area. Doing so will allow more room to insert the pilot chute and will minimize a difficult extraction. 6. Flip the pilot chute over. Page • 60:88 section 4 : folding pilot chute for BOC 09354 - 11/26/2003 Rev 0
V E C T O R O W N E R ’ S M A N U A L 7. Fold one quarter of the pilot chute toward the center. Repeat this for the opposite side. 8. Fold once more in half lengthwise so the pilot chute resembles a hotdog bun. 9. Insert the pilot chute into the pouch until only the handle is exposed. Once again, pat the pouch to flatten it, reducing the amount of force necessary to extract the pilot chute. note If you have any excess bridle after inserting the pilot chute, tuck it away in the BOC pouch, between the pilot chute and the container. 09354 - 11/26/2003 section 4 : folding pilot chute for BOC Page • 61:88 Rev 0
Page 1 and 2:
Rev 0
Page 3 and 4:
○ ○ ○ ○ ○ ○ ○ ○ ○
Page 5 and 6:
V E C T O R O W N E R ’ S M A N U
Page 7 and 8:
V E C T O R O W N E R ’ S M A N U
Page 9 and 10: V E C T O R O W N E R ’ S M A N U
Page 23 and 24: COMMONLY USED TOOLS V E C T O R O W
Page 59: V E C T O R O W N E R ’ S M A N U
Page 89: Rev 0
show all

Micron

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?