Optimod-Surround 8685 V1.0 Operating Manual - Orban

2-48
INSTALLATION ORBAN MODEL 8685
tered, the 8685 will ignore the command.
• You can apply this command anytime after the 8685 boots up. The 30-minute
timeout does not apply.
• This command is useful in interfacing automation systems to the 8685.
2. To recall a Setup:
Command Response
RS XXXXXXX[PASSCODE]� (valid passcode and Setup name)
ON AIR: XXXXXXX
(invalid passcode)
[no error message is issued]
In the above table: XXXXXXX = the Setup name;
PASSCODE = any valid passcode.
• If a non-existent Setup name, control value, and/or an invalid passcode is entered,
the 8685 will ignore the command.
• You can apply this command anytime after the 8685 boots up. The 30-minute
timeout does not apply.
• This command is useful in interfacing automation systems to the 8685.
3. To restore factory defaults:
Command Response
RESTORE FACTORY DEFAULTS� Are you sure (yes/no)?�
YES� (factory defaults restored)
Restored�
NO�
(or any response other than
YES�”)
(abort)
Defaults not restored�
To protect against accidental loss of settings, you must enter the entire command
string and a “YES” response in uppercase.
Restoring factory defaults does the following:
• Deletes all User Presets
• Resets all global parameters to factory default settings
• Deletes all Automation Events
• Restores Remote Interface inputs 1-8 to “no function”