Optimod-Surround 8685 V1.0 Operating Manual - Orban

OPTIMOD SURROUND PROCESSOR INSTALLATION 2-49
4. To unlock an 8685:
The following command assigns an ALL ACCESS passcode. This passcode is then
available from the front panel or when you connect normally via the 8685PC application
(through the 8685’s Serial Port #1 or optional Ethernet connections).
Command Response
PW ########� (valid passcode entry) Accepted�
(invalid passcode entry) Denied�
Valid arguments follow the same rules for passcode entries made from the front
panel and via 8685PC:
• Passcode length must be 1 to 8 characters.
• Only alphanumeric characters are allowed (0…9 and A…Z). No punctuation or
extended characters are allowed.
• Lower case letters included in the argument will automatically be converted
to upper case.
5. To change the IP Address:
Command Response
IP XXX.XXX.XXX.XXX� (valid IP address)
IP: xxx.xxx.xxx.xxx entered�
(invalid IP address)
ERROR. Using IP: yyy.yyy.yyy.yyy�
IP?� Using IP: yyy.yyy.yyy.yyy�
In the above table: XXX.XXX.XXX.XXX = the specified IP address;
yyy.yyy.yyy.yyy = the present (or default) IP address in
use.
192.168.254.254 is the factory default.
Any out-of-range or invalid characters render invalid the whole IP address
that you entered.
6. To change the Subnet Mask:
Command Response
SN XXX.XXX.XXX.XXX� (valid subnet)
SN: xxx.xxx.xxx.xxx entered�
(invalid subnet)
ERROR. Using SN: yyy.yyy.yyy.yyy�
SN?� Using SN: yyy.yyy.yyy.yyy�