F9000N Manual - Fisnar.fr

F9000N & F2004N Series Operating Manual
Section 3 : Teaching Overview Rev. C- Oct. 11
4. Point Type Functions Summary
4.1. Point Menu
Below is a list of Point type functions that are found under the Enter key (Point menu):
Function
Dispense Dot
Line Start
Line Passing
Line End
Arc Point
Circle
Center
Dummy
End Program
Description
Registers the current XYZ location (and R position of tip) as
a Dispense point for dot dispensing.
Registers the current XYZ location (and R position of tip) as
a Line Start point for line dispensing.
Registers the current XYZ location (and R position of tip) as
a Line Passing point. This is a location on the line where the
tip changes direction, such as at the corner of a rectangle.
Registers the current XYZ location (and R position of tip) as
a Line End point.
Registers the current XYZ location (and R position of tip) as
an Arc Point. Arc Points are used to dispense material in an
arc or circle.
Registers the current XYZ location (and R position of tip) as
a Circle point. Circle points are used to dispense material in
a circle.
Registers the current XYZ location (and R position of tip) as
a center point of circle. Center points are used to dispense
material in a circle.
Registers the current XYZ location (and R position of tip) as
a Dummy point. The tip will simply pass through this point.
This is useful for avoiding obstacles on the work piece.
Registers the current memory address as the end of the
program.
- Page 32 -
© 2010 Fisnar Inc.