F9000N Manual - Fisnar.fr

F9000N & F2004N Series Operating Manual
Section 4 : Programming Example Rev. C- Oct. 11
Instruction
Display Shows
The display shows that we are at memory address
1 and that it is empty.
Jog the dispense tip to the first location in the
diagram above (1: Line Start).
6
To jog the X, Y, Z axes and R position of tip, press
the respective Jog keys.
Press the
►
SPD+
key to jog fast. See
ADDR: 1 PROG: 10
X: 0 Y: 0
Z: 0 R: 0
Teaching Overview Section 3:2.4 Jogging for
more information.
Once the tip is at the correct X, Y, Z, R location for
the first point (1: Line Start), press the ENTER
7
key, then 2 (from page 1/5 of the Point Menu) to
register the location as a Line Start point.
(Note: From now on, the symbols and the values
displayed for the X, Y, Z axes and R position will
not be written in the column “Display Shows” of
ADDR:2
EMPTY
PROG:10
this example).
The display will show that we are at memory
address 2 and it is empty. Jog the tip to the X, Y, Z,
ADDR:3
EMPTY
PROG:10
R location of the second point (2: Line Passing).
8
When the location is correct, press the ENT key,
then 3 (from page 1/5 of the Point Menu) to
register the location as a Line Passing point.
Now jog the tip to the location of the third point
ADDR:4
PROG:10
9
(3: Arc Point). When the location is correct, press
the ENT key, then 1(from page 2/5 of the Point
Menu) to register the location as an Arc Point.
EMPTY
- Page 44 -
© 2010 Fisnar Inc.