F9000N Manual - Fisnar.fr

More documents

Recommendations

Info

F9000N & F2004N Series Operating Manual Section 5 : Dispensing Parameters Rev. C- Oct. 11 Section 5: Dispensing Parameters - Page 50 - © 2010 Fisnar Inc.
F9000N & F2004N Series Operating Manual Section 5 : Dispensing Parameters Rev. C- Oct. 11 1. Dispense End Setup After dispensing a dot or line, it is often required to raise the tip a short distance at a slow speed. This allows the material to cleanly break free from the tip, without „dragging‟ material where it is not wanted. The distance and speed which the tip rises after dispensing is controlled by the L.Length and L.Speed settings. After the tip rises the length specified by L.Length at the speed specified by L.Speed, the tip will continue rising to the Z Clearance height at the speed specified by H.Speed. The purpose of specifying a Z Clearance height is to allow the tip to rise high enough to clear any obstacles it may encounter on the way to the next point. Z Clearance H.Speed 2: Tip continues rising to Z Clearance height at H. Speed L.Length 1: After dispensing, the tip rises to L.Length at L.Speed Values for H.Speed, L.Speed and L. Length are registered with the Dispense End Setup function by pressing the SETUP key, then choosing Dispense End Setup. Once Dispense End Setup values have been registered at a memory address, all points after that memory address will use the values specified. If Dispense End Setup values are registered again, at a higher memory address, all the points from that memory address forward will use the new values. - Page 51 - © 2010 Fisnar Inc.
Page 1 and 2: F9000N & F2004N Series Operating Ma
Page 11 and 12: Axis Control General Condition F900
Page 49: F9000N & F2004N Series Operating Ma
Page 59: F9000N & F2004N Series Operating Ma
Page 100 and 101:
F9000N & F2004N Series Operating Ma
Page 102 and 103:
Page 104 and 105:
Page 106 and 107:
Page 108 and 109:
Page 110 and 111:
Page 112 and 113:
Page 114 and 115:
Page 116 and 117:
Page 118 and 119:
Page 120 and 121:
Page 122 and 123:
Page 124 and 125:
Page 126 and 127:
Page 128 and 129:
Page 130 and 131:
Page 132 and 133:
Page 134 and 135:
Page 136 and 137:
Page 138 and 139:
Page 140 and 141:
Page 142 and 143:
Page 144 and 145:
Page 146 and 147:
Page 148 and 149:
Page 150 and 151:
Page 152 and 153:
Page 154 and 155:
Page 156 and 157:
Page 158 and 159:
Page 160 and 161:
Page 162 and 163:
Page 164 and 165:
Page 166 and 167:
Page 168 and 169:
Page 170 and 171:
Page 172 and 173:
Page 174 and 175:
Page 176 and 177:
Page 178 and 179:
Page 180 and 181:
Page 182 and 183:
Page 184 and 185:
Page 186 and 187:
Page 188 and 189:
Page 190 and 191:
show all

F9000N Manual - Fisnar.fr

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?