AXIS 231D+/232D+ Network Dome Camera User's Manual

8AXIS 231D+/232D+ - Using the Network Dome CameraSetting the root password1. When accessing the video server for the first time,the Configure Root Password dialog appears.Note: Before you enter your password at this point, you can secure configurationof the root password via HTTPS by creating a self-signedcertificate. To do so, click the Create self-signed certificate... buttonin the Create Certificate window, and then proceed as follows.2. Enter a password and re-enter, to confirm thespelling. Click OK.3. The Enter Network Password dialog appears. Enterthe User name: root.Note: The default administrator user name root is permanent and cannot be deleted or altered.4. Enter the password as set in step 2 above, and click OK. If the password is lost, thecamera must be reset to the factory default settings. See Resetting to Factory DefaultSettings, on page 47.5. If required, click Yes to install the AXIS Media Control (AMC). You will needadministrator rights on the computer to do this.If the AXIS 231D+/232D+ has been suitably customized, the buttons and other itemsdescribed below will be displayed accordingly on the Live View page. The followingprovides an overview of each button:The Video Format drop-down list allows the video format on the LiveView page to be temporarily changed.The Output buttons control an output directly from the Live View page. Thesebuttons are configured under Setup > Live View Config > Layout.Pulse - click this button to activate the port for a defined period of time, suchas to switch on a light for 20 seconds.Active/Inactive - click these buttons to manually start and stop a connecteddevice, such as to switch a light on/off.These buttons start/stop the Sequence Mode. This mode is created in Setup >Live View Config > Sequence mode and automatically displays the view frompreset positions at set intervals.The Action buttons trigger an action directly from the Live View page. Thesebuttons are configured under Setup > Live View Config > Layout. Click thesebuttons to manually start and stop events.