HY-IDE Software User's Manual

More documents

Recommendations

Info

4.3 PC Online OTP ProgrammingFigure 0-12Figure 4-13Blank Check, Programming, Verify and Read command can be implemented when theprogrammed file being successfully loaded into programmer or IDE Flash Memory. On the contrarythose commands will not be activated if the download is malfunctioned.Figure 4-14Figure 4-15Figure 4-16Make sure the selected programming IC part no. is the same with the OTP part no. in topicwindow as Figure 4-4 described. When programmer executes Blank Check, Programming and Verifycommands, Program will check whether the IC part no. and OTP programming part no. are identical. Ifthe part no is different, the data will not be written into OTP and an error message will display ininformation columnas© 2008 HYCON Technology Corp.www.hycontek.comAPD-HYIDE001-V01_HYIDE SUM_EN
HY-IDE Software User’s ManualFigure 4-14 described.If users intend to find out whether the part no. is correct before programming, point the cursorto ”IC Connection Status Display” and click the mouse left key. If the IC part no. is correct, a messagewill show up as Figure 4-15. If it is incorrect, the message will display as Figure 4-16. If “EnableProgram Times” is ticked, the spare program times will display in the message column as illustratedFigure 4-17.Figure 4-174.3.1 Blank CheckThe internal code of Blank ICs that have not yet been programmed is 0xFFFF. The purpose ofchecking the IC is to assure the OTP address content is 0xFFFF.If the IC selection is correct and the content is empty, a message will appear as Figure 4-18.Figure 4-18If the IC selection is incorrect or the content is not empty, a message will show up as Figure 4-19described.Figure 4-194.3.2 ProgramThe purpose of programming is to write Compiler accomplished program into IC OTP. Whenprogramming is completed and the IC is assembled as finished goods, it can operate the program asusers commanded.Program the downloaded or assembly finished Hex file (displayed at the bottom of the column)in the selected IC and verify the correctness of the programming content (please refer to Chapter 4.2.1or 4.2.2 for programming procedures).© 2008 HYCON Technology Corpwww.hycontek.comAPD-HYIDE001-V01_HYIDE SUM_EN –page 51
Page 1 and 2: HY-IDE SoftwareUser’s Manual© 20
Page 3 and 4: HY-IDE Software User’s Manual4.3.
Page 5 and 6: HY-IDE Software User’s ManualFigu
Page 9 and 10: HY-IDE Software User’s ManualSet
Page 13 and 14: HY-IDE Software User’s Manual‣
Page 17 and 18: HY-IDE Software User’s Manual3. H
Page 19 and 20: HY-IDE Software User’s Manual(4)
Page 21 and 22: HY-IDE Software User’s Manualleft
Page 23 and 24: HY-IDE Software User’s Manual3.3
Page 37 and 38: HY-IDE Software User’s ManualDisp
Page 41 and 42: HY-IDE Software User’s Manual4. P
Page 47 and 48: HY-IDE Software User’s Manual3. A
Page 49: HY-IDE Software User’s ManualDown
Page 53 and 54: HY-IDE Software User’s Manualfile
Page 55: HY-IDE Software User’s Manualnot

HY-IDE Software User's Manual

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?