HY-IDE Software User's Manual

HY-IDE Software User’s Manual4.4 Offline Programming4.4.1 Program DescriptionAs the development process evolves to mass-production, the programmer can be used alonewhen programming on the production line. There is not necessary to connect the programmer to thePC.OTP ProgramJ1 DC Jack, 9V input.Figure 4-26Notice: the case is 9V; the core is Ground (VSS).U6 USB port. Users use this port to connect to PC.P3 Program PIN output. PIN and OTP is connected.PIN1 = VPPPIN2 = SCKPIN3 = DIPIN4 = DOPIN5 = VSSPIN6 = VDDL1 Error message light display, red LED.L2 Success message light display, green LED.S2 Blank Check button, for offline operation.S3 Program button, for offline program operation.To implement offline operation, Hex file must be firstly downloaded to programmer FlashMemory. Please refer to Chapter 4.2.1 or 4.2.2 for procedures.S2 Button can check if the IC is blank.S3 Button is programming button. Its procedures are: Blank Check Program Verify.If ”Program Protection” of “Assemble Option” is ticked up before downloading data to FlashMemory, program protection will be executed after Verify completed. If ”Program Protection” is© 2008 HYCON Technology Corpwww.hycontek.comAPD-HYIDE001-V01_HYIDE SUM_EN –page 54