Software application manual - VTP UP

Appendix B: Parameter Ranges and Default ValuesB.1 Configuration and Method Parameter Ranges and DefaultsTable B1 below lists all configuration and method parameters, along with each parameter’srange, units and default value.Table B1. Parameter Ranges and Default ValuesParameter Range Units DefaultSystem ConfigurationMode DC or Pulse DCCommunications port COM1...COM4, USB COM1Enable channel 2 yes or no noEnable guard channel yes or no noEnable thermal organizer yes or no noEnable event marker on AZ yes or no noEvent marker height -20 to +20 % 5 %Lock keypad yes or no yesDC ModeCh 1 Potential -2000 to +2000 mV 50 mVCh 1 Filter Constant 0.2, 0.5, 1.0, 2.0, 5.0, 10.0 sec 5.0 secCh 1 Gain Range 10 pA to 1 mA in steps of 1, 2, -- 100 µA5, 10, 20, 50, 100, 200, 500Ch 1 Output Voltage -1.0, -0.1, +0.1 or +1.0 V +1 VCh 1 Baseline Offset -50 to +50 % 0 %Ch 2 Potential -2000 to +2000 mV 50 mVCh 2 Filter Constant 0.2, 0.5, 1.0, 2.0, 5.0, 10.0 sec 5.0 secCh 2 Gain Range 10 pA to 1 mA in steps of 1, 2, -- 100 µA5, 10, 20, 50, 100, 200, 500Ch 2 Output Voltage -1.0, -0.1, +0.1 or +1.0 V +1 VCh 2 Baseline Offset -50 to +50 % 0 %Guard Potential -2000 to +2000 mV 0 mVPost-RunCh 1 Enable Clean Cell yes or no noCh 1 Clean Cell Potential -2000 to +2000 mV 0 mVCh 1 Clean Cell Duration 1.0 to 120.0 sec 1 secCh 2 Enable Clean Cell yes or no noCh 2 Clean Cell Potential -2000 to +2000 mV 0 mVCoulochem ® III Analyst Driver - Version 1.0 61User’s Manual