JW220-UM-251 - Graphtec

7. DISASSEMBLY AND REASSEMBLYHow to reinstall the Y motor(1) Reattach the Y motor in the reverse order in which it was detached.Note: When installing the linear encoder tension spring, make sure the linear encoder strip ispositioned in the slit of encoder sensor at the rear of the carriage.(2) Loosen the two M3L6 binding head screws attaching the idler base bracket.Idler base bracketM3L6 binding head screw(3) Move the carriage head to the far left (Maintenance station).(4) Press down on the Y belt at the 3rd slider shaft holder to measure the Y belt tension using aforce gauge.3rd slider shaft holder3rd slider shaft holderfrom the left sideY beltForce gaugeJW220-UM-251-93707-17