JW220-UM-251 - Graphtec

7. DISASSEMBLY AND REASSEMBLYHow to reinstall the carriage assembly(1) Reattach the Y belt to the carriage assembly in the reverse order in which it was detached.Reference:If you detached the Y belt from the belt clamp, install the Y belt as shown below.Leave two notches here.Y belt clampY beltLeave three notches here.Spread a suitable quantity of glue (for rubber and plastic) to the outside of the rubber basewhen installing the belt clamp on the rubber base. Next install the Y belt clamp on the areawhere the glue was spread on the rubber base.Carriage headRubber baseSpread a suitable quantity ofthe glue here.(2) Reattach the carriage assembly to the slider shaft in the reverse order in which it wasdetached.Clean the slider shaft using IPA if the slider shaft is dirty.(3) Temporarily reattach the slider shaft to the carriage guide plate in the reverse order in which itwas detached.(4) Remove the two screws attaching the left and right platen panels, and then mount the heightadjustment jigs to the left and right platen panels using the M3L25 binding head screws asshown below.M3L25 binding head screwHeight adjustment jigMount the height adjustment jig in theright side platen panel in the same wayas shown in this photograph.JW220-UM-251-93707-31