JW220-UM-251 - Graphtec

More documents

Recommendations

Info

7. DISASSEMBLY AND REASSEMBLYHow to reinstall the ink supply tube(1) Connect the new tube to the T-type joint. (Required length: about 910 mm for each tube)(2) Use IPA to clean the inside of the sponge bracket where the sponge was attached withdouble-sided adhesive tape.(3) Affix double-sided adhesive tape (5 x 240 mm) to the inside of the sponge bracket where thesponge was attached.SpongeThe sponge is attached bydouble-sided adhesive tape tothe inside of this bracket.(4) Clamp all the ink supply tubes with the clamps.Clamp(5) Insert the tube into the carriage.Insert the tube into the carriage here.(6) Temporarily connect the tube to the carriage head.JW220-UM-251-93707-36
7. DISASSEMBLY AND REASSEMBLY(6) Confirm the piping as shown in the photograph below.Correct pipingBlack ink supply tubeColor ink supply tubesThe black ink supply tubeis piped under the color inksupply tubes.Incorrect pipingBlack ink supply tubeColor ink supply tubesThe black ink supply tubeis piped over the color inksupply tubes.The ink supply tube isprotruding from the flexiblecable.If the black ink supply tube is piped over the color ink supply tube, reconnect the tube again sothat the piping is the correct.If the ink supply tube is protrudes from the flexible cable, cut off the extra length of tube at theend of tube. At this time, the cut edge must be cut to a right angle.JW220-UM-251-93707-37
Page 1 and 2:
JW220-06SERVICE MANUALMANUAL NO. JW
Page 3 and 4:
CONTENT1. INTRODUCTION ............
Page 5: 9. TROUBLESHOOTING ................
Page 12 and 13: 2. PART NAMES and FUNCTIONSRear Vie
Page 14: 3. STANDARD ACCESSOIES and OPTIONSJ
Page 22 and 23: 7. DISASSEMBLY AND REASSEMBLYHow to
Page 24 and 25: 7. DISASSEMBLY AND REASSEMBLY7.1.3
Page 26 and 27: 7. DISASSEMBLY AND REASSEMBLY(7) Re
Page 28: 7. DISASSEMBLY AND REASSEMBLY7.1.6
Page 31 and 32: 7.2.2 How to Replace the Main Board
Page 33 and 34: 7.2.4 How to Replace the Power Supp
Page 41 and 42: 7. DISASSEMBLY AND REASSEMBLY(5) De
Page 47 and 48: 7.2.13 How to Replace the Carriage
Page 49 and 50: 7. DISASSEMBLY AND REASSEMBLY(20) R
Page 53 and 54: 7. DISASSEMBLY AND REASSEMBLY(7) Re
Page 55: 7. DISASSEMBLY AND REASSEMBLY(8) De
Page 59: 7. DISASSEMBLY AND REASSEMBLY(11) C
Page 62 and 63: 8. ELECTRICAL ADJUSTMENTS8.2 Upgrad
Page 64 and 65: 8. ELECTRICAL ADJUSTMENTS(5) Select
Page 66 and 67: 8. ELECTRICAL ADJUSTMENTS8.3.2 How
Page 68 and 69: 8. ELECTRICAL ADJUSTMENTS8.3.3 How
Page 71 and 72: 9. TROUBLESHOOTING9. TROUBLESHOOTIN
Page 73 and 74: 9. TROUBLESHOOTINGSymptom Verificat
Page 75 and 76: 9. TROUBLESHOOTINGSymptom Verificat
Page 77 and 78: 9.5 Ink Supply9. TROUBLESHOOTINGSym
Page 79 and 80: 9.7 How toDraw Ink from the Ink Car
Page 81: 9. TROUBLESHOOTING(9) Attach the pr
Page 84 and 85: 10. PARTS LISTSOuter Casing94820133
Page 86 and 87: 10. PARTS LISTSBottom Chassis171314
Page 88 and 89: 10. PARTS LISTSMain Frame51159144 1
Page 90 and 91: 10. PARTS LISTSY Drive219 171816156
Page 92 and 93: 10. PARTS LISTSCarriage813149161211
Page 94 and 95: 10. PARTS LISTSStand108511972341211
Page 96: 10. PARTS LISTS10.9 OtherStandard A
show all

JW220-UM-251 - Graphtec

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?