920i Installation Manual V4.01 - Rice Lake Weighing Systems

FEATURE MenuParameter Choices DescriptionLevel 2 submenusDATETIMEDATEFMTDATESEPTIMEFMTTIMESEPDECFMT DOTCOMMADSPRATE 11–80CONSNUM 00–9999999CONSTUP 00–9999999UID 1unit-IDTRUCK OFFMODE1MODE2MODE3MODE4MODE5MODE6ALIBIOFFONCFGPWD 00–9999999reset=999999Allows selection of date format and date separator character. See Level 3 submenuparameter descriptions.Use the TIME/DATE softkey or the SD serial command to set the date. See Section 9.0 onpage 89 for information about using the serial commands.Allows selection of time format and separator character. See Level 3 submenu parameterdescriptions.Use the TIME/DATE softkey or the ST serial command to set the time. See Section 9.0 onpage 89 for information about using the serial commands.Specifies whether decimal numbers are displayed using a period (DOT) or comma as thedecimal symbol.Display update rate. Specifies the display update rate, in the number of 100-millisecondintervals between updates. The default value, 1, provides about 10 updates per second.The maximum value updates the display every 8 seconds.Consecutive numbering. Allows sequential numbering for print operations. The consecutivenumber value is incremented following each print operation that includes in the ticketformat. When the consecutive number is reset, it is reset to the value specified on theCONSTUP parameter.Specifies the consecutive number start-up value used when the consecutive number isreset by sending the KCLRCN serial command or a CLRCN digital input. Value specifiedmust be in the range 0–9 999 999.Specifies the unit identification number. Value specified can be any alphanumeric value, upto eight characters.Specifies the truck mode used. If selected, the indicator switches from normal mode to theselected truck mode. See Section 7.0 on page 68 for more information about using thetruck modes.MODE1: Auto clear ID, keyed tares, value swappingMODE2: Auto clear ID, no keyed tares, value swappingMODE3: Stored ID, keyed tares, value swappingMODE4: Stored ID, no keyed tares, value swappingMODE5: Stored ID, keyed tares, no value swappingMODE6: Stored ID, no keyed tares, no value swappingSpecifies whether data storage is used by the alibi feature to allow reprinting of anytransaction.Use the SOFTKEYS parameter to enable a softkey for recalling alibi print transactions.NOTE: Alibi tracking must be turned on when in OIML mode in order to meet thelegal-for-trade requirement.Configuration password. Specify a non-zero value to restrict access to all configurationmenus. The value 999999 is used to reset the indicatorNOTE: If a configuration password is specified, be sure to record the password and keep itin a safe place. If the configuration password is lost or unavailable, the indicator must becleared (reset configuration and calibration parameters) to continue use.To clear the indicator, press the setup switch, then enter 999999 (six nines) at theconfiguration password prompt. The unit performs a RESETCONFIGURATION then returnsto the setup mode configuration display.Table 3-7. FEATURE Menu ParametersConfiguration 43