ATEX compliant - SMC ETech

ATEX Compliant Air Cylinder/Standard Series 55-CS1Note) All other specifications(dimensions, drawings, etc.)are the same as the non ATEX type.SpecificationsStyleFluidProof pressure 2)Max. operating pressure 2)Min. operating pressurePiston speedCushionAmbient and fluid temperatureThread toleranceStroke length tolerance (mm)MountingNon-lubeATEX category 1) 95°C (T5) Ta –10 to 40°CII 2GDc115°C (T4) Ta 40 to 60°CAir (Non-lube)1.57MPa0.97MPa0.05MPa50 to 500 mm/sNone, air cushion0 to 60°C (No freezing)JIS class 2+1.0 +1.4 +1.8250 or less: 0 , 251 to 1,000: 0 , 1,001 to 1,500: 0+2.2 +2.61501 to 2000: 0 , 2001 to 2400: 0Basic, Foot, Front flange, Rear flange,Single clevis, Double clevis, Centre trunnionNote 1) This cylinder can be used in zones 1 and 21 and in zones 2 and 22.If the cylinder is used with SMC category 3 type auto switch, then thecylinder can only be used in zones 2 and 22 and not in zones1 and 21.Note 2) For the CDS1 diameter 180 and 200 the Proof pressure is 1.2MPaand the Max. operating pressure is 0.7MPa.SymbolAccessoriesStandardAccessoryMountingClevis pin,Cotter pinRod end nutSingleknuckle jointDoubleknuckle joint(Knuckle pin,Cotter pin)BasicFootFrontflangeRearflangeSingleclevisDoubleclevisCentretrunnion— — — — — —Max. StrokeTube material Aluminum alloy Carbon steel tubeBoreMountingbracket125140160180200250300BasicRear flangeSingle clevisDouble clevisCentre trunnion1000 or less1000 or less1200 or less————FootFront flange1400 or less1400 or less1400 or less————BasicRear flangeSingle clevisDouble clevis1000 or less1000 or less1200 or less1200 or less1200 or less1200 or less1200 or lessFootFront flange1600 or less1600 or less1600 or less2000 or less2000 or less2400 or less2400 or less(mm)With auto switchB, G, C, D, T L, F1000 or less 1400 or less1000 or less 1400 or less1200 or less 1400 or less1200 or less 1500 or less998 or less 998 or less----15