salisbury

SUBSTATION COVER-UPBus GuardsSubstation Cover-up and barrier equipment is usedfor routine maintenance where outages are difficultto get to. These covers may be applied with rubbergloves or hot sticks. These covers are made fromType I orange ABS plastic. This equipment is notintended for permanent or semi-permanent barrier orinsulating applications. Use these covers to protectagainst accidental contact only. These covers arenot to be left installed for extended periods of timeespecially when in contact with both a grounded andenergized object.1374Bus GuardBus Guards are easily interlocked with each other.To interlock units determine the length of bus to becovered. Place one unit on the bus then the other,pulling it over the first cover until the dimplesinterlock at the required length. This guard has avoltage rating of 36.6 kV*.Bus “T” Guards interlock two or three bus guardsat bus tap “T” connections and 90 degree angles. Tointerlock units, first position the bus guard then slidethe “T” guard over the top interlocking the dimples.This guard has a voltage rating of 36.6 kV*.1375Bus “T” GuardBus End Guards cover the ends of a substation bussupported by station post insulators. The slot andinsulator grip hole can be easily enlarged in the fieldwith a sharp knife. This cover also has a guide beadfor a trim fit. This guard has a voltage rating of26.4 kV*.Eye kit is available on page C-10.*guarded Ø to guarded Ø .9992Bus End GuardCat. No. Dimension Description ASTM Weight ea.in. ( mm ) Voltage Class lbs. ( kgs )Bus Guard1374 5.25”x 9.5”x4.5’ ( 133 x241x1.4m ) Impact Resistant 4 6.0 ( 2.7 )Bus “T” Guard1375 5”x15”x25” ( 127x381 x635 ) ABS Plastic 4 4.0 ( 1.8 )Bus End Guard9992 8.5”x12”x24” ( 216x305x610 ) UV Resistant 3 5.0 ( 2.3 )Linear PolyethyleneAll guards are tested to ASTM F712 and are manufactured to ASTM F968 specificationsC-8SALISBURY Insulating Plastic Guards and Covers. www.whsalisbury.com