Docu Cutter DC-545 HC/DC-545 HCEX

Manual Programming - DC545 HCEXChapter 5Manual Programming - DC545 HCEXThis chapter describes how to manually program the Docu Cutter.The Docu Cutter is manually programmable with 80 sets of job dimensions or program numbers. Each setof dimensions are stored and recalled by a program number. (a P.45, “Factory Preset Jobs”)Prior to Programming a Job1Before programming a job carefully measure,in millimeters, the required slits, cuts andcreases. See the Figure 1 for reference andFigure 2 for a detailed description of eachfunction.Record the values in “Customer ProgramedJobs”. Remember that all measurements,except MARK 1, are in millimeters.Familiarize yourself with the following illustrationsand instructions to make the programmingprocess easy and trouble free.IMPORTANT NOTES:There are a total of five slitters. Two slitters arefor the margins and the remaining threeslitters are for the center of the sheet.There is a guillotine cutter that performs cutsperpendicular to the line of the paper travel.P–01? (01––80)OK?––>SETFigure 1PAPER FEEDING DIRECTIONCutReg. Mark(Optional)Bar Code(Optional)ProgramNumberSlitCrease5There is creasing unit that performs creasesperpendicular to the line of the paper travel.Figure 253