Docu Cutter DC-545 HC/DC-545 HCEX

Manual Programming - DC545 HCEXDefinition of Programming TermsAlso consider that the unprintable margin of a digital press is typically 3 to 5 mm from the edge of the sheet, so the edgeof the image should not be placed more than 205 mm from the reference edge.To avoid the problem of the image drifting into the unprintable margin (which would result in a white edge inside theimage area), the image should possess a bleed of (typically) 2mm.With all these factors combined, it is recommended that the right trim position is located between 202 and 204 mm fromthe reference edge.1202-204mmtypicallyWorkaround - Should a job be presented that requires a side trim of less than 200 mm, use the right center slitter, OP1,or OP2 slitter to remove the waste from the side. The waste will exit onto the delivery tray.5) Skewed Output on Small PiecesDepending on the job layout it is possible to have skewed output when small pieces are processed. In part, this problemis due to the design of the rubber feed rollers. Each roller has cutouts that reduce the gripping and drive area for thepaper. In addition, the slitter units add drag as the card contacts the slitter housing and cutter wheels.5Workaround - Analyze the slitter positions and reprogram the job. Switch the center and option slitter units cuttingpositions in order to better balance the paper as it travels through the slitters.59