Prisma Plus LV Switchboards - POWERLAB

6040100604010060401006040100604010060401006040100604010060401006040100604010060401006040100404040Functional unitsSystem GHuman-switchboard interfaceCatalogue numbersDD381705DD381684Measurement devices with interfaceand plastic mounting platesFront plate with cut-outs, four mounting plates and one plainmounting plate for 72 x 72 mm devices.AAAAPresentationThe interface for 72 x 72 and 96 x 96 mm measurement devices is made up of:b a special front plate with cut-outs (03904) for plastic mounting platesb plastic mounting plates for the 72 x 72 or 96 x 96 mm devices.The front plate can be equipped with:b five mounting plates with cut-outs for 72 x 72 mm devicesb four mounting plates with cut-outs for 96 x 96 mm devices.It can also be equipped with plain plastic mounting plates to blank off any unusedpositions. The plain mounting plates can be easily cut out for lamps, pushbuttons or72 x 72 mm devices.Each mounting plate has a cable-running system for auxiliary wires and can beidentified by a label.InstallationThe interface for 72 x 72 and 96 x 96 mm devices is installed similar to a front plate:b in the device zone of enclosuresb on a partial door with cut-outs in wall-mount and floor-standing enclosures(except IP55).The degree of protection for installed devices is IP30.Cat. no. selectionDesignationCat. no.Front plate (3 modules) for five 72 x 72 mm or four 96 x 96 mm devices 03904Mounting plate for 72 x 72 mm with cut-outs 03902deviceplain 03900Mounting plate for 96 x 96 mmdevicewith cut-outs 03903plain 03901Doors with cut-outs for the measurement-device interfaceMounting on a cubicle door cut-out (System P).Partial door6 modulesIP30/31/43 enclosures (08851) see page 78DD381685DD381687DD381688AAAAThe mounting plates have guides for auxiliarywires.Mounting plates can be identified by a label(not supplied).Note: For degree of protection IP55, devices must be installed behind a transparent door. If theyare installed on the door, use the mounting plates intended for IP55 enclosures (see page 86).Mounting in the device zone of an enclosure (System G).DD380862AAAAVisor for measurement devicesPresentationThe interface with the plastic mounting plates for 72 x 72 mm and 96 x 96 mmdevices can be mounted on a visor.The visor can be installed on 300 and 400 mm wide doors with cut-outs in cubiclesor on partial doors in wall-mount and floor-standing enclosures.It is supplied with a drilling diagram for mounting on a plain door.Cat. no. selectionDesignationCat. no.Visor for measurement devices 03928DD381686AVisor mounted on a cubicle door cut-out.100A 60100A 60A 60100Visor mounted on the partial door of an enclosure.50