Manual (PDF) - Univers by FTE

4InstallationEnglishThe following steps assume, that ...... the receiver is properly set up and the satellite antenna is correctly installed and aligned.In case of eventual problems with the direction of the SAT-antenna, please read the page42 about the antenna direction menu.Important:Unplug the receiver if you wish to carry out connection tasks.Connection ...... for connecting your receiver to the satellite antenna (or to the antenna socket at aSMATV installation) you need a sufficiently long Sat coaxial cable suitable for digitalreception. If the F connectors are not mounted into the connecting cables yet, pleaseproceed to mount the connector as follows:Finally screw the F connector carefully into the cable until the epoxy insulation reachesthe connector’s thread end.Important:Pay special attention not to cause a short circuit in the connector (it is a very commonmistake to leave a shield’s wire touching the inner conductor). This short circuit will makethe reception impossible.Finally connect the cable (properly mounted) into the receiver’s IF IN connector (1)located in the back panel.Connecting to a TV set and a video tape recorderIn order to obtain an optimal picture quality you should use Scart connectors for both theTV set and VCR.10 Version 1.0 © UNIVERS