MPH series video encoders - Teleste

Management Interface9 10 11 12 13 14 15 16GeneralMPH encoders support web user interface (WebUI), ONVIF configurationinterface and command line user interface (CLI) for various configurationpurposes.1 2 3 4 5 6 7 8PC/PSIONReceivedataTransmitdataSystemgroundD9femaleScrewterminal2 63 7DATA 2 TXDATA 2 RXDATA 2 GNDMPHencoderMgmtoutputMgmtinput5 8 GroundLocal management connection (CLI)and management cable (CIC506)pinout (D9 female/screw terminal).WebUIMPH series video encoders can be fully configured using Web user interface(WebUI). You can access the Web user interface via web browser.ONVIFMPH series video encoder support ONVIF (Open Network VideoInterface Forum) global interface (version 1.02).CLI – Command Line InterfaceMPH series video encoder include a command line interface (CLI) forconfiguration purposes. The CLI is a text-based interface that allows theuser to interact with the operating system by entering commands andoptional arguments. CLI is accessible through any terminal emulatorapplication (e.g. Hyper Terminal or PuTTY). The command structure isthe same for all session types. A typical CLI usage is to access thedevice IP address settings. By default the data channel 2 is set for CLIusage. The data channel 2 can be set to normal RS232 data mode withWebUI when needed.Note! Data 2 channel can be set either general RS232 datatransport mode or CLI mode (not simultaneously). The defaultfactory setting is CLI mode (Hard and soft factory reset restoresthe data channel 2 to the CLI mode).Local CLI connectionThe local CLI session can be establish via data channel 2 by using aserial data connection (RS232) cable (type Teleste CIC506).Note! Data 2 port must be set to CLI mode .Remote CLI connectionOver the IP network you can make Telnet or SSH connection to open thecommand line interface remotely. SSH protocol secures your data session.8 MPH100/400 series video encoders WebUI user manual