MPH series video encoders - Teleste

More documents

Recommendations

Info

Metadata is a data channel andone of the Onvif features which cancarry events, PTZ status, and/orvideo analytics data for networkvideo devices.Note! Only even port numbers canbe used for RTP, and then thefollowing odd port number shall beused for RTCP (RFC 1889).Metadata ConfigurationsNote! Parameters cannot bechanged when streaming is active.CommonName:AnalyticsScene Description:PTZ StatusStatus:Position:Event SubscriptionTopics:Message content filter:Multicast ConfigurationDestination address:Destination port:Time To Live (TTL) (1..255):Auto start:Quality of Service (DSCP):Click “Metadata” under the Media Configuration menu. MetadataConfigurations page appears on the screen. You can add a metadataconfiguration to an existing media profile, adding a metadata configurationto a profile means that streams using that profile contain metadata. Fourmetadata configurations are supported. In addition to video analyticsinformation, metadata can transmit PTZ camera status and position to theOnvif client. Carrying other events such as “loss of video signal” is done bymetadata channel. Metadata transmits video analytics information likemotion detection over RTP stream in XML format. Currently MPH transmitsmotion detection information, PTZ camera status (feedback) and video lossevent over metadata channel._________________________________________________________User defined alias name for metadata configuration (max 64 chars)._________________________________________________________Enable/disable scene description. When enabled, adds video analyticsresults from each analyzed frame to metadata. With motion detection thisincludes amount of motion detected and defined threshold level._________________________________________________________Enable/disable PTZ control status.Enable/disable PTZ camera position.Event subscription defines which events are included to metadata stream.Event subscription topics.Event subscription message content filter._________________________________________________________You can set a multicast address and port number for a Metadata stream,the multicast address can be the same as video stream multicast addressbut with different port number.Multicast Time-To-Live for metadata packets.If enabled, metadata streaming starts automatically after reboot (does notimmediately start or stop streams).Defines QoS class in differentiated services (DiffServ) traffic management.DSCP (Differentiated Services Code Point) is a field in the IP headers thataffects the priority of packet in the network per hop basis.32 MPH100/400 series video encoders WebUI user manual
CommonType:Module:Link status:Ethernet MAC:Link Level ConfigurationMode:MTU (1000 to 1500):IPv4 ConfigurationEnable IPv4:IP address resolution:IP address:Netmask:Gateway:Network SettingsClick “Network” under the Media Configuration menu. NetworkSettings page appears on the screen. Device’s network settings can bechanged on this page.Ethernet Interface_________________________________________________________Device’s Ethernet Interface type.Shows the status of SFP module.Shows the current link status and connection type.MAC address of the device._________________________________________________________You can select the connection mode, Auto negotiation or fixed rate.You can adjust the maximum transmission unit based on your connectiontype, default value is 1492 bytes. The MTU range is from 68 to1500._________________________________________________________IPv4 enabled (change not supported).You can set a static IP address for the unit (in case of static IP the usercan set IP address, subnet mask and gateway address) or select DHCPmode to obtain IP address automatically. When you enable ZeroConfprotocol, the device will set an IP address randomly to itself if it fails tofind the DHCP server after few trials.IP address of the device.Netmask address of the device.Gateway address for router definition.MPH100/400 series video encoders WebUI user manual 33
Page 1 and 2: User Manual - MPH100/400MPH series
Page 4 and 5: MPH Series Video Encoders Front and
Page 6 and 7: Getting startedQuick instructions11
Page 8 and 9: Ethernet InterfaceEthernet connecti
Page 10 and 11: Management Interface9 10 11 12 13 1
Page 12 and 13: Starting WebUI sessionTo create a W
Page 14 and 15: Configuring Video ChannelsVideo con
Page 16 and 17: 1. Video InterfacesClick “Video I
Page 18 and 19: 3. Video EncodersClick “Video Enc
Page 20 and 21: Advanced simple profile:H.264 optio
Page 22: Video streaming performanceThe foll
Page 25 and 26: Configuring Data Channels9 10 11 12
Page 27 and 28: CommonName:Mode:Baud rate:Data bits
Page 29 and 30: ONVIF PTZ service1. In order to act
Page 31 and 32: CommonName:Input filter:Filtering t
Page 33: Video Analytics configuration isact
Page 37 and 38: Local TimeTime zone:Local time:Syst
Page 39 and 40: The Real Time Streaming Protocol(RT
Page 41 and 42: Command Line Interface - CLIGeneral
Page 43 and 44: Connection methods - TCP/IPThis cha
Page 45 and 46: Devmgmt commandEnter the devmgmt co
Page 47 and 48: Network commandEnter the network co
Page 49 and 50: MPH featuresVideo MPH101/111 MPH102
Page 51 and 52: NotesMPH100/400 series video encode

MPH series video encoders - Teleste

Create successful ePaper yourself

Delete template?

Save as template?