MPH series video encoders - Teleste

Network commandEnter the network command to view network menu:**************************************network menu**************************************linkstatuslinkleveliphostnamednsntpuphelpexit-------------------------Use CLI commands in network menu to configure device IP settings.Use the linkstatus command to seeinformation from the network interfaceand link status.Entering help linkstatus displays information about the linkstatus command:linkstatusDescription:Displays network interface and link statusUse the linklevel command to set linkmode and mtu size.Entering help linklevel displays information about the linklevel command:linklevel [] []Description:Sets the link mode and/or mtu size.mode_str: Can be one of the following:auto : Auto negotiation100FD : 100 mbps full duplex100HD : 100 mbps half duplexmtu_size: MTU size in bytes (Valid range: 64 to 1500)If no arguments are passed, the command will display currentconfigurationUse the ip command to changedevice IP settings.Entering help ip displays information about the ip command:ip [] [][]Description:Sets the IP mode. Also sets IP address, subnet and gateway incase of static IP mode onlyIf no arguments are passed, the command will display thecurrent configuration.An example how to change deviceIP address, subnet and gateway:networkip -mode=static -addr=172.31.252.13-mask=255.255.0.0 -gate=172.31.2.1: static / dhcpIf manual mode is selected, then ip address, subnet mask andgate way also should be provided[]: IP address[]: Subnet mask[]: Default gatewayCaution: If ip address is changed, you might have to loginusing new IP address. Change in IP address might make thedevice in-accessbile from your network if configured to adifferent subnetMPH100/400 series video encoders CLI user manual 45