MPH series video encoders - Teleste

Configuring Data Channels9 10 11 12 13 14 15 16Data connectionsThe MPH100/400 encoder provides two independent bi-directional datachannels. Supported data modes for data channel 1 are RS422, RS485-2w and RS485-4w. Data channel 2 is fixed for RS232 mode only. Dataport settings can be configured from web user interface (WebUI) orCommand Line Interface (CLI).1 2 3 4 5 6 7 8DATA 1 OUT+DATA 1 OUT-DATA 1 IN+DATA 1 IN-DATA 1 GNDDATA 2 TXDATA 2 RXDATA 2 GNDLower screw terminal connector onfront panel is used for data connections.Data channel 1 is fully configurable and supports RS422, RS485 2-wireand RS485 4-wire modes .ONVIF PTZ service is only available fromdata channel 1, whereas data channel 2 is used either for RS232 datamode or command-line interface usage. Both channels support tunnellingprotocol and can be connected to the PTZ controller application.The default factory settings are:• Data channel 1: RS485-2w• Data channel 2: mode is set to CLI (Command Line Interface) usagePin Signal RS232 RS422 RS485-2w RS485-4w1OUT + OUT +2 OUT - OUT -3 Data 1IN + IN/OUT + IN +4 IN - IN/OUT - IN -5 Ground Ground Ground6TX7 Data 2RX8 GroundData connector’s pinout and supported data types.Led Colour ModeGreenActive Connection.Terminal server TCP connection is established.TBlinking GreenOn stream.OFF / DarkNo stream.T - (terminal server) Led indicator operation. This LED indicates thestatus of Terminal server activity on RS422/485 port.Data 1 Data 2Tunnelling protocol x xONVIF PTZ protocolxRS232xRS422, RS485xCommand line interfacexMPH unit provides two data channels for PTZ cameras on Terminalserver page.MPH100/400 series video encoders WebUI user manual 23