MPH series video encoders - Teleste

The Real Time Streaming Protocol(RTSP) ia a network protocol used toestablish and control media sessionsbetween devices. For example, avideo Decoder sends RTSP playcommand to the video Encoder.Note! If port clash is detected whileconfiguring RTSP server port, devicegives an error message and disablesRTSP server. After that you have togive an unused (valid) port andenable RTSP server again.Session Announcement Protocol (SAP) isa protocol for broadcasting multicastsession information. A SAP listeningapplication can listen to the SAP multicastIP address and construct a guide of alladvertised multicast sessions (RFC 2974).SAP uses Session Description Protocol(SDP) as the format of the sessiondescriptions. Announcement data is sentusing IP multicast and UDP.Network ServicesHTTP enabled:HTTP port:RTSP enabled:RTSP port:Session Announcement Protocol (SAP)Enabled:Multicast TTL:Announcement interval:Administrative scope:Device DiscoveryWS-Discovery enabled:Simple Network Management Protocol (SNMP)SNMP v2c enabled:Read community:Write community:Trap destination 1...4:SyslogServer:Services SettingsClick “Services” under the Administration menu. Services Settingspage appears on the screen. This page allows you to enable/disabledifferent network services available and configure following parametersof services:_________________________________________________________HTTP is always enabled.Port 80 is used always.Enable/disable RTSP (Real time streaming protocol) server.Configure RTSP server port._________________________________________________________Enable/Disable SAP service.Multicast Time-To-Live for SAP packets (1...255).SAP timing in seconds (1...999). Retransmit time of SAP-packet. Thistime has to be same at both encoder and decoder pairs.Range of multicast IP addresses advertised with SAP. When the streammulticast address is within the SAP scope, end of the scope is used.Otherwise default SAP-address 224.2.127.254 is used. Default SAPscopeis 239.0.0.0 - 239.255.255.255._________________________________________________________This enables ONVIF device discovery feature.Currently this service is not upported.Enable/Disable SAP SNMP v2c protocol.Specifies the read only community (public or private).Specifies the write community (public or private).Trap Destination defines the IP address of an Agent receiving traps_________________________________________________________Syslog is a standard for computer data logging. By using syslog you cancollect messages sent from MPH on the syslog sever.Shows syslog server IP address. If this field is left blank then remotelogging is disabled.MPH100/400 series video encoders WebUI user manual 37