BROOKFIELD DV-II+ PROGRAMMABLE VISCOMETER Operating ...

DV-II+Serial and Analog OutputsNo ConnectionNo ConnectionTransmit Data (TxD)High Speed Print(Note 1)Serial Ground123456789Analog GroundAnalog % Torque(Note 2)Analog Temperature(Note 3)High Speed Print(Note 1)Notes:Figure G11. Placing a jumper across pins 4 and 9 causes the DV-II+ to output printerdata at a 3 line-per-second rate. No jumper across pins 4 and 9 retains theonce-per-second printer output rate.2. This is a 0-1 volt d.c. output where 0 volts corresponds to 0% torque and1 volt corresponds to 100 % torque with a resolution of 1 millivolt (0.1%).3. This is a 0-3.75 volt d.c. output where 0 volts corresponds to -100°C and3.75 volts corresponds to +275°C with a resolution of 1 millivolt (0.1°C).Analog Output:The analog outputs for temperature and % torque are accessed from the 9-pin connector located onthe rear panel of the DV-II+. The pin connections are shown in Figure G1.The output cable (Part No. DVP-96Y) connections are:Red Wire:Black Wire:White Wire:Green Wire:Temperature OutputTemperature Ground% Torque Output% Torque GroundNote:Please contact Brookfield Engineering Laboratories or your local dealer/distributor for purchase of the DVP-96Y analog output cable.Brookfield Engineering Labs., Inc. Page 64 Manual No. M/97-164-F1102