Pneumatic cylinders - Duncan Rogers

P1DCylinderDesign variants for P1D Standard, P1D Clean, P1D Flexible porting and P1D Tie-RodUsing P1D cylinders as a platform, a number of differentdesigns can be produced to suit differing requirements. Pleaserefer to the order key on pages 28 - 51 for the designation ofeach variant.P1D complete working unitP1D Standard can be ordered with a factory-fitted valve andpiping. The valve series is the robust and compact Vikingseries.Of course, the entire range of P1D accessories can also beused for the P1D with built-in valve, and cylinders can beordered with factory-fitted accessories and sensors.For more information, see page 45.P1D-LP1D cylinder with piston rod lockingThe P1D cylinder is available in a version with piston rodlocking, allowing the piston rod to be locked in any position.The lock unit, of the air/spring actuated type, is integrated inthe front end piece of the cylinder. The lock unit can be usedfor braking as well as locking. With no signal pressure, the fullforce of the lock is applied to the piston rod, and the lock isreleased at 4 bar signal pressure. Lock units are available forP1D Standard(P1D-L) and P1D Clean (P1D-D) in dimensions Ø32-125 mm.P1D Standard can be ordered with a lock unit and a built-invalve (P1D-4).For more information, see page 48P1D-DP1D cylinder with internal piston rod threadAll P1D cylinders are available with an internal piston rodthread where a short installation length is required1306.05www.parker.com/euro_pneumatic