Pneumatic cylinders - Duncan Rogers

P1DCylinderComplete accessory programmeP1D offers a complete ISO, VDMA and AFNOR compatibleaccessory programme, with a wide range of pistonrod and cylinder mountings for both pivoted and fixedoperation. Several of these types of mountings are availablein stainless steel. The new ”drop-in” sensors areavailable with both reed and electronic operation, with awide choice of connector types and cable lengths.New, mechanically protected sensor technologyThe body extrusion has recessed sensor grooves onthree sides of the cylinder. The new sensors are of the”drop-in” type, and are quickly and easily installed in theT-groove from the side. Both the cable and the sensorare protected in the groove. Choose a sensor with 3 or10 m cable, 8 mm connector or the new M12 connector.Optimised cushioningThanks to the plastic inserts in the end covers, eachcylinder bore has been given individual flow geometry.This provides optimised cushioning, which is quickerand easier to set and adjust.Smooth, quiet operation and long service lifeAll seals and end-of-stroke washers are made from polyurethane(PUR), the bearings and piston are made fromproven engineering plastics with excellent bearing propertiesand all cylinders are greased at the factory with atransparent, foodstuffs-approved grease. Altogether thisgives the P1D very long service life and smooth, quietoperation.06.05www.parker.com/euro_pneumatic