Pneumatic cylinders - Duncan Rogers

P1DCylinderCushioning screw with positive geometryTo offer the best hygiene properties, the projecting cushioningscrew, is sealed with rubber seal against the endcover. This eliminates dirt-collecting cavities and givesthe best hygiene, since it is so easy to clean.Sealing plugsFour plastic sealing plugs are supplied with everyP1D Clean cylinder. These are installed in the end coverscrews which are not used for the cylinder installation. Toensure the sealing function, the plugs can be used onlyonce i.e. they can not be re-used. When installed in theend cover screws, they should be tapped lightly with ahammer to securely fix.Patent applied system for integrated standard sensorsThe P1D Clean cylinder has a system of sensors, whichare fully integrated into the body extrusion, to give thecylinders a clean external design. Up to four sensorschosen from the range of P1D standard sensors, reed orelectronic operation, can be mounted in two dedicatedgrooves beneath a transparent, sealed moulding.Tightening the stop screw onto the cam shaft, will lockeach sensor in the desired position, with great force. Thesensor LEDs are always fully visible, which facilitatescommissioning, adjustment and trouble-shooting. Theentire sensor system has a hose-proof design, equivalentto IP65. P1D Clean can be ordered with factoryfittedsensors in the end positions, which can then easilybe moved to any other position along the entire stroke.Up to four integral sensorsCylinders for two integral sensors have two undividedcamshafts along the entire stroke. Free choice of cableexit, front or rear. There is also a version with dividedcamshafts for up to four sensors, which are installed twofrom each end cover, with cable exit front and rear.Simple sensor adjustmentThe sensors are mounted into their groovesthrough the opening in a transparent, sealedcover. The sensor cables have strain reliefand are sealed.The sensor position is easily adjusted byundoing a set screw and using the cable tomove the sensor to the desired position.Once the sensor has been locked in its newposition, the protective cover is installedagain.06.05www.parker.com/euro_pneumatic