BoosterpaQ®- Hydro MPC

Finally the resulting current setpoint (SP) is shown.9.4.6 Measured values (1.2.4)9.4.8 Pump 1...6 (1.3 to 1.8)Fig. 14Measured valuesDescriptionThis display gives a general status of all measured and calculatedparameters.Note9.4.7 Analog inputs (1.2.5)Fig. 15The lines "Power consumption" and "Energyconsumption" are only shown in Hydro MPC-Ebooster systems.Analog inputsDescriptionThe display shows an overview of the analog inputs and thecurrent measured values of each input. See sections9.7.28 Analog inputs (4.3.8), 9.7.29 Analog inputs (4.3.8.1 to4.3.8.7) and 9.7.30 Analog inputs and measured value (4.3.8.1.1to 4.3.8.7.1).TM04 6185 5009TM04 6193 5009Fig. 16 Pump 1DescriptionThis display shows the operational state of the individual pumps.The pumps may have different operating modes:• AutoTogether with the other pumps in automatic operation, thepump is controlled by the PI controller which ensures that thebooster system delivers the required performance (pressure).• ManualThe pump is not controlled by the PI controller. In manualoperation, the pump has one of the following operating modes:– Max.The pump runs at a set maximum speed. (This operatingmode can only be selected for variable-speed pumps.)– NormalThe pump runs at a set speed.– Min.The pump runs at a set minimum speed. (This operatingmode can only be selected for variable-speed pumps.)– StopThe pump has been forced to stop.Besides information about the operating mode, it is possible toread various parameters in the status display, such as these:• current operating mode• control source• speed (only 0 or 100 % are shown for mains-operated pumps)• power consumption (only CRE pumps and CUE controlledpumps)• energy consumption (only CRE pumps and CUE controlledpumps)• operating hours.9.5 Operation (2)In this menu, the most basic parameters can be set, such assetpoint, operating mode, control mode and forced control ofpumps.TM03 2268 480723