BoosterpaQ®- Hydro MPC

10.2 VLT FC 202Press [EXTEND MENU] to access all parameters.Grundfos settingParameter FunctionValue001 Language English002 Motor Speed Unit Hz003 Regional Settings North America020 Display Line 1.1 Power [hp]021 Display Line 1.2 Motor Voltage022 Display Line 1.3 Motor Current023 Display Line 2 Large Frequency024 Display Line 3 Large Speed [rpm]100 Configuration Mode Open Loop103 Torque Characteristics Variable Torque121 Motor Power [HP] Nameplate122 Motor Voltage Nameplate123 Motor Frequency Nameplate124 Motor Current Nameplate125 Motor Nominal Speed Nameplate190 Motor Thermal Protection ETR trip 1302 Minimum Reference 20.000 Hz303 Maximum Reference 60.000 Hz304 Reference Function External Preset310 Preset Reference 100.00%313 Reference Site Remote341 Ramp 1 Ramp up Time 1.50 s342 Ramp 1 Ramp down Time 3.00 s412 Motor Speed Low Limit [Hz] 0.0 Hz414 Motor Speed High Limit [Hz] 62.0 Hz419 Max Output Frequency 65.0 Hz510 Terminal 18 Digital Input Star513 Terminal 29 Digital Input Preset reference on540.0 Function Relay Drive ready542.0 Off Delay, Relay 2.00 s610 Terminal 53 Low Voltage 0.00 V611 Terminal 53 High Voltage 10.00 V614 Terminal 53 Low Ref. / Feedb. 20.000 Hz615 Terminal 53 High Ref. / Feedb. 60.000 Hz1400 Switching Pattern 60 AVM1401 Switching Frequency 5.0 kHzFactory setting of VLT FC 200To recall the factory settings of all parameters, follow one of theprocedures below:1. Select parameter 14-22.2. Press [OK].3. Select “Initialisation” (for NLCP select “2”).4. Press [OK].5. Disconnect the power supply.6. Reconnect the power supply.7. All parameters are now factory-set, except RFI 1, protocol,address, baud rate, minimum response delay, maximumresponse delay, maximum inter-char delay, operating data,historic log and fault log.or1. Disconnect the power supply.2. Press and hold [STATUS] + [MAIN MENU] + [OK] andreconnect the power supply.3. All parameters are now factory-set, except operating hours,the number of power-ups and overtemp’s and overvolt’s.69