Installation and Configuration Guide - Axceleon

E N F U Z I O N F O R R E N D E R F A R M S I N S T A L L A T I O N A N D C O N F I G U R A T I O N G U I D EIf you do not see the Web page, please see the section below titled Common Installation Problems.Please make sure this step is successful before you continue to the next installation step.5.1.5 Installing EnFuzion on an EnFuzion Compute NodeThe steps to install and configure an EnFuzion Compute Node are as follows:Make sure that you have created an enfuzion user account on the EnFuzion Compute Node. SeeSection 5.1.3 for directions.Login as the enfuzion user.Copy the EnFuzion installation package to the enfuzion user’s Desktop or home directory. TheEnFuzion installation package for Mac OS X is called enfuzion-3d.-darwin.ppc32.tgz.Double click on the installation package to unpack it. This will result in a directory with the installerprograms. Install the EnFuzion Compute Node by running the InstallNode applications, as shown in Figure 5-1.You will be prompted to configure the Compute Node by telling it the network address of the EnFuzionControl Root Computer. You must supply a valid static network address for the Control RootComputer. For the one-machine test configuration, you can simply enter localhost.Upon a successful installation of a Compute Node, it should connect to the Control Root Computerautomatically. You can verify this from Nodes page from the EnFuzion Web Interface, as shown inFigure 5-3.Reboot the Compute Node after installation.Figure 5-3: Compute Node Running, as Seen from the EnFuzion Web Interface39