Liebert Challenger 3000 with iCOM

Installation (Applicable to all Models)2.4.1 Handling With Skid• Always keep the unit upright, indoors and protected from damage.• If possible, transport the unit using a fork lift; otherwise, use a crane with belts or cables, avoidingpressing on the top edges of the packaging.• If using a fork lift, make sure the forks, if adjustable, are spread to the widest allowable distanceto still fit under the skid.NOTICERisk of overhead interference. Can cause unit and/or structure damage. Refer to theinstallation plans prior to moving the unit to verify clearances.While on the skid, the unit is too tall to fit through a standard height doorway (83 inches or2108 mm tall). Any attempt to move the unit, while on the skid, through a standard doorwaywill cause damage to the unit.2.4.2 Removal of Skid• Remove the plywood skirting that keeps the skid and unit in place.• Raise the Challenger 3000 off the skid. Liebert recommends using a fork lift (see Figure 1)or similar machine to ensure that the unit is lifted properly.• Once the unit is raised, the skid can be removed.Figure 1 Removing Challenger from skidRemove plywood skirting holdingunit and skid in place.Raise unit with forkliftor similar machine.Table 1 Unit net weightModelLb. (kg)036E/035E 535 (243)060E/059E 545 (247)042A/040A 615 (279)067A/065A 670 (304)046WG/045WG 700 (318)071WG/070WG 750 (340)061G/058G 785 (356)068C/072C 545 (247)102C/101C 555 (252)6