ALPHA Distribution Boards and Terminal Blocks

© Siemens AG 2010
ALPHA 8HP Molded-Plastic Distribution Systems
Accessories
Support racks and cable space covers
■ Design
#
"
!
%
$
ALPHA 8HP, support rack and cable space cover
Support rack
Support rack made of galvanized sheet section, with threadchanneling
screws for connection.
Punched holes with spacings of 307 mm × 307 mm enable the
different sized distribution boards to be fixed using captive nuts.
Lateral profiles for creating distribution boards with a width of
two to six sections, support profiles for creating distribution
boards with a height of three to six sections.
The height can be expanded by one section respectively using
support profile extensions, and the width by adding further racks
to existing distribution boards using connecting brackets.
One section corresponds to the basic dimensions of the
ALPHA 8HP system: 307 mm.
Cable space cover
Cable space cover for mounting on the ALPHA 8HP support
rack, with plug-in molded-plastic covers in light gray, RAL 7035,
available in heights 370 and 677 mm.
With the 8HP9 057 double flange, enclosures can also be fitted
under the cable space cover.
1 $ $
& '
$ Lifting lug
% Support profile
& Wall-mounting bracket
( Support rail
) Support profile extension
* Supporting foot for free-standing installation
+ Support struts
, Front cover
- Top cover
. Baseboard
/ Lateral profile
0 Corner profile
1 Corner cover
2 Joining sheet
3 Side support
4 Side panel
Individual parts for support rack and cable space cover
!
"
#
$
8
If connecting several support racks, you need to order the
matching covers. For each width expansion, only one set of side
panels 4 and one set of corner covers 1 are required. We therefore
recommend ordering these cable space covers for the expansion
as individual parts – without the specified units.
Siemens ET A1 · 10/2009
8/41