z/OS V1R9.0 UNIX System Services Command ... - Christian Grothoff

NO
Indicates that no debugging information is to be written.
YES
Indicates that debugging information is collected while the OMVS command
runs.
EVENT
Causes additional debugging information to be written whenever certain
internal events occur in the OMVS command.
DATA
Causes any data received from or sent to the workstation to be written.
Also, debug information for internal events is recorded.
Also, the ddname for the OMVS debug data set is always SYSFSUMO.
ECHO | NOECHO
Enables OMVS to control the visibility of the input area. The default is
NOECHO.
ECHO
Allows OMVS to hide or unhide the input area.
NOECHO
Prevents OMVS from hiding and unhiding the input area.
ENDPASSTHROUGH(ATTN | CLEAR | CLEARPARTITION | ENTER | NO | PA1 |
PA3 | PF1 | PF2 | PF3 ... PF24 | SEL)
Specifies a 3270 key that ends TSO/3270 passthrough mode and forces OMVS
to return to the shell session. Because this key would be used only during
application development, the default is ENDPASSTHROUGH(NO); all 3270
keys can be used by the 3270 application.
ATTN
Specifies the 3270 key. In some 3270 applications, this key may be
changed to before it is seen by the TSO/E OMVS command. If so,
OMVS will never see the key; specify instead of .
With some terminal connections, the key may not be available.
CLEAR
Specifies the 3270 CLEAR key. In some TS0/3270 applications, the TSO/E
OMVS command will not see when the CLEAR key is pressed. In
these cases, specifying ENDPASSTHROUGH(CLEAR) will have no effect.
CLEARPARTITION
Specifies the 3270 key. This key is effective only if the
application is using explicit 3270 partitions.
ENTER
Specifies the 3270 ENTER key. This key is useful only if the 3270 application is
completely driven by PF or PA keys.
NO
No breakout key; this is the default.
OMVS
PA1
Specifies the 3270 key. For some TSO/3270 applications, is
changed to before OMVS sees it. In these cases, you should specify
ENDPASSTHROUGH(ATTN).
Chapter 3. TSO/E commands 857