SUNNY WEBBOX - User Manual - SMA Solar Technology AG

SMA Solar Technology AG Appendix
15 Appendix
15.1 Allocating an IP Address in a Local Network
You select a static IP address (Internet Protocol). Use the address range which is available to your
router. In most cases the address range of the router lies between 192.168.0.1. and
192.168.255.254. If necessary refer to the manual of your router.
Please note during the allocation of the IP address that the first three address parts of the IP address
must be identical for all participants of the same network. You may not allocate the same IP address
twice.
Example:
Router: 192.168.0.1
Computer 1 192.168.0.2
Computer 2 192.168.0.3
Sunny WebBox 192.168.0.168
15.2 Determining the Network Settings of the Sunny WebBox
With the following steps you can determine the current network settings of the Sunny WebBox. You
can then configure your computer to allow you to access the Sunny WebBox again (see section
10.3 "Ethernet Network" (page 62)).
1. If necessary, remove the write protection of the SD card.
2. Insert the SD card into the SD card slot of the Sunny WebBox (see section 9.6 "Storing
Recorded Data on an SD Card" (page 57)).
☑"MEMORY" LED flashes orange. The Sunny WebBox saves data to a specific directory
folder on the SD card The name of the data file is "WebBox_[SerialNumber]", whereby
[SerialNumber] designates the serial number of the respective Sunny WebBox.
3. Wait until the "MEMORY" LED glows green.
4. Remove the SD card from the SD card slot of the Sunny WebBox.
5. Connect the SD card to a computer.
6. Open the directory on the SD card ("WebBox_SerialNumber").
This directory contains a file named "config.xml".
7. Open the "config.xml" with a text editor or Internet Explorer.
☑ Open the configuration file of the Sunny WebBox. See the configuration file for the required
information (see section 15.3 "Structure of the Config.xml File" (page 86)).
User Manual SWebBox-BEN111033 85